LISUN
Home
/
Ingress Protection & Mechanical Test Equipment

LS60745-F103 Hammer Drill Durability Tester – LISUN

LS60745-F103

LISUN LS60745-F103 durability rig for drills, impact drills and hammers to IEC 60745-2-1 and 2-6: no-load and loaded cycling, 100–400N axial force.

Ingress Protection & Mechanical Test Equipment
Mechanical Test Machine
Floor-Standing Test Rig
IEC 60745-2-1:2019; IEC 60745-2-6:2019; GB 3883.6-2007; GB 3883.7-2012
Enquire About This Product
LISUN LS60745-F103 Hammer Drill Durability Tester

Overview

The LISUN LS60745-F103 carries out the endurance tests for hand-held drills, impact drills and hammers in IEC 60745-2-1 and IEC 60745-2-6, using the test arrangement of Figure 103. It runs the tool on and off for many hours, at set voltages, in different positions and under axial load, to show whether the tool develops an electrical or mechanical hazard over a long working life. It suits tools up to 2.5kW.

The rig has an electrical control cabinet and a mechanical test frame. The control cabinet sets the supply voltage to the tool from 0 to 250V and displays the current, and times the on and off periods, the test duration and the rest intervals.

Test sequences

In the no-load test the hammer mechanism is disengaged and the tool runs for 12 hours at 1.1 times rated voltage and then 12 hours at 0.9 times rated voltage, in cycles of 100s on and 20s off. At each voltage it runs about 4 hours in each of three positions: horizontal, pointing up and pointing down. The frame rotates the tool to 0°, 90° and 180°.

In the load test the tool runs at rated voltage for four 6-hour periods with at least 30 minutes between them, in cycles of 30s on and 90s off. A spring applies a set axial force so the impact mechanism works steadily; the steel ball, pads, rubber plates and weighted steel base for the Figure 103 arrangement are supplied.

Key Specifications

ParameterValue
Tool ratingUp to 2.5kW
Supply220V 50Hz (120V 60Hz optional); compressed air 5–8 bar
ControlMitsubishi PLC, 7-inch touchscreen
Tool voltage0–250V adjustable, current displayed
Tool positions0°, 90°, 180°; manual reversal
Rotation speed0–360°/s, settable
On / off time0–999.9s each, settable
Test and total time0–9999h, settable
Rest interval0–9999min, settable
Axial force100, 125, 150, 175, 200, 250, 300, 350 or 400N
Impact heads0.7, 1.4, 2.3 and 3.4kg (including connector)
Steel ballØ38mm
Steel pads100, 140, 180 and 220mm, with matching rubber plates
Steel base90kg plus 9 × 30kg weights
Size and weightCabinet 60 × 40 × 75cm, approx. 100kg; frame 40 × 40 × 200cm, approx. 390kg

Features

Applications

Frequently asked questions

Does it cover IEC 62841?

LISUN builds this rig to IEC 60745-2-1 and IEC 60745-2-6. Ask us if you need to confirm suitability for the IEC 62841 equivalents.

Is compressed air needed?

Yes, a supply of 5 to 8 bar.

Related Reading